Routing and routing some more!
Okay, so here's my network:
Everything outside of the red circle is done, and soon we will do the part inside the red circle.
I added a static route to the ADSL modem/router/AP (192.168.1.1) as such:
Destination: 192.168.2.0, gateway: 192.168.1.200
So now all 192.168.1.0/24 clients can talk to all 192.168.2.0/24 clients, and this works.
When we add the 192.168.3.1 access point, where do I add that static route, and with what Gateway?
Would it be, Destination: 192.168.3.0, gateway: 192.168.2.20, and add this to the FreeBSD gateway ?
Or would it be, Destination: 192.168.3.0, gateway: 192.168.1.200, and add this to the ADSL modem?
Or do I need to do both?
EDIT: I forgot to mention, the 192.168.3.0/24 clients do not need internet access!
Routing, oi vey!
FreeBSD addict since 4.2-RELEASE.
My FreeBSD wiki.
Last edited by Weaseal; 19th August 2008 at 12:53 PM.
your AP bridge is layer 2 and the two connected networks are on different subnets, so either you need a /16, or put a router between the switch and AP on both ends. You just want .2.0/24 to be able to route to .3.0/24 and vice versa - yes?
if 192.168.2.1 is the def gtwy for hosts on .2.0/24 - you will need a static route there for traffic bound for .3.0/24
The IPs assigned the the APs are for the mgmt interface -yes?
|Thread||Thread Starter||Forum||Replies||Last Post|
|trouble with binat routing||SystemDog||OpenBSD General||3||21st December 2009 04:01 PM|
|Loose UDP routing?||spiller37||OpenBSD Security||4||1st August 2009 12:10 AM|
|double nat routing||giagni||General software and network||5||22nd May 2009 08:10 PM|
|Firewall routing||Magoo||FreeBSD General||9||4th November 2008 04:39 PM|
|OpenBSD and routing||cchapman||OpenBSD General||5||25th July 2008 06:55 PM|