Took hardisk out and replaced to another machine: CAN"T Mount
I took out the harddisk of my computer and placed it into a new one. When I ran Freebsd 7.0 on it, I get a the following error:
can't stat /dev/ad4s2e: No such file or directory
can't stat /dev/ad4s2d: No such file or directory
can't stat /dev/ad4s2f: No such file or directory
because my old computer keeps rebooting half way and I think that my FreeBSD partition has been damaged because of that.
I have looked into a few sources and decided to run fsck to check.
Upon entering fsck, I get errors such as
/dev/ad0s2c No write access
/dev/ad0s2c unexpected inconsistency; run fsck manually
So I have decided to boot into single user mode. However, this is difficult for me because normal boot will cause my system to crash. I can only boot with acpi disabled but when I boot into single user mode, I am getting the similar crash as the system inidicates:
GEOM_Label for provider ad4s1 is ntfs/MAX_Software
and then the computer freezes:
I think that my harddisk may have a few bad sectors, and this is causing the system to crash when it loads the geom_label line to the screen. Aside from reformatting, how do I do the following:
1) Run fsck or similar or any tools that I can burn to a cd to check for bad sectors on my harddisk?
2) Rebuild my /etc/fstab
3) Edit the manual so that my FreeBSD system always start with ACPI disabled
4) log into single user mode with ACPI disabled?
Any help will be appreciated. I am really lost.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Fixed "xinit" after _7 _8, "how" here in case anyones' "X" breaks... using "nvidia"||jb_daefo||Guides||0||5th October 2009 10:31 PM|
|How to "configure" and mount a USB Drive already in use||IronForge||OpenBSD General||10||1st September 2009 06:36 PM|
|"Thanks" and "Edit Tags".||diw||Feedback and Suggestions||2||29th March 2009 12:06 AM|
|Newbie-friendly "printing in OpenBSD" guide wanted||Shagbag||OpenBSD Packages and Ports||5||7th July 2008 10:26 PM|