RAID-1 OpenIndiana vs NetBSD vs OpenBSD
Wanted to use two 1TB USB drives using RAID-1.
My choices are NetBSD 6.0, OpenBSD 5.1 (5.2 wasn't released a few days ago) and OpenIndiana.
After a few failed attempts of trying raidframe on NetBSD I gave up, although I did actually have it setup according to the documentation it wouldn't boot properly.
Next I used softraid on OpenBSD and it was easy to setup and only took a minute to do so before installing. After 24 hours my rebuild of the RAID-1 was at 42%.
My third install was OpenIndiana and installed to one drive. Then attempted to mirror and had an error saying I can't use an EFI labeled disk. Quick search led me to a document and 5 minutes later I started resilvering. These were the results:
# zpool status rpool2 pool: rpool2 state: ONLINE scan: resilvered 2.21G in 0h10m with 0 errors on Fri Nov 2 12:55:45 2012 config: NAME STATE READ WRITE CKSUM rpool2 ONLINE 0 0 0 mirror-0 ONLINE 0 0 0 c3t0d0s0 ONLINE 0 0 0 c6t0d0s0 ONLINE 0 0 0 errors: No known data errors
|Thread||Thread Starter||Forum||Replies||Last Post|
|OpenIndiana is it dead or alive?||gpatrick||Solaris||3||27th September 2012 01:33 PM|
|OpenIndiana - I heard you were dead||shep||News||1||8th August 2012 05:04 AM|
|OpenIndiana build 148 released||J65nko||News||0||21st December 2010 08:36 PM|
|New to OpenBSD: problem with music, raid?||barum87||OpenBSD General||3||24th June 2010 04:04 AM|
|RAID Boot volume on OpenBSD 4.6 using softraid||csc||OpenBSD General||2||26th February 2010 02:51 PM|