|
|
|||||||
| OpenBSD Installation and Upgrading Installing and upgrading OpenBSD. |
|
|
Thread Tools | Display Modes |
8th October 2010
|
|||
|
|||
Cannot reset hardware ath0
Hello everyone,
First of all, I would like to say that this it my first post!  Also, I would like to say that I did search the forums before posting this. I am no stranger to OpenBSD, but I have just installed it for the first time on an HP laptop. Everything works great as I expected, accept the wireless card. When I configure it to "up" status, I get the error: "Cannot reset hardware ath0: HAL status: 0" It seems to give me a different HAL status every time, but HAL status 0 always occurs when setting the interface to "up". I also get the error when setting the IP address. It's an Atheros AR5007 card. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ath0: no carrier | FreeBee | FreeBSD General | 6 | 9th January 2010 07:59 AM |
| FreeBSD 7.2@amd64 atheros problem ath0: stuck beacon; resetting (bmiss count 4) | asmo | FreeBSD General | 0 | 6th June 2009 11:02 AM |
| Freebsd Ath0 mode monitor | mateusrico | FreeBSD General | 3 | 8th April 2009 09:34 AM |
| Hardware recommendation: what hardware to buy for my new FreeBSD desktop? | Broodjegehaktmetmayo | General Hardware | 92 | 11th February 2009 09:43 PM |
| Ath0 + wpa, how configure? | nesca2in1 | FreeBSD General | 10 | 2nd July 2008 04:12 AM |
Threaded Mode