Problems with ntfs partition located on a SATA driver.
I am a new FreeBSD user and I currently have 2 harddisks, one ATA which has the main BSD slice on it and one SATA that serves as storage. (Note that the partition on the SATA drive is ntfs).
I first installed BSD without plugging in the SATA HD, and everything went well. However, when I plug in the SATA driver after I turn off my computer and rebooted, my boot screen freezes and my computer froze and I can't login.
Knowing that SATA HDS allows you to Hot-swap, I turned on the system, and plugged in the harddisk while BSD was on. Everything worked fine, and I can mount it using the mount command.
However, I realized that when I turn off my computer and rebooted, I get the same error. What is the most effective way to go about this problem? I don't want to manually do this procedure over and over again.
Reply With Quote
|Thread||Thread Starter||Forum||Replies||Last Post|
|em driver problems? taskq em goes up to 100% CPU||ibmed||FreeBSD General||0||30th December 2008 08:27 PM|
|Mounting ntfs drive as rw using fusefs-ntfs||caesius||FreeBSD General||3||12th October 2008 12:08 PM|
|E-SATA?||PatrickBaer||OpenBSD General||28||6th October 2008 12:41 AM|
|mount problems with ntfs drive||shinjii||FreeBSD General||3||25th June 2008 01:33 AM|
|problems with nvidia-driver-169.12||greencross||FreeBSD General||8||21st May 2008 02:41 PM|