I've installed fusefs-ntfs port today and it broke my FreeBSD 7.0 system. First it rebooted my system twice in attempt to install the port and then after I managed to install it and configuring it reading the /usr/local/share/doc/ntfs-3g/README.FreeBSD file and rebooting it could not mount /usr and it falls into single-user mode asking me to run fsck manually and so I did.
fsck prints tons of output asking me [RECONNECT], [CLEAR] some dirs, etc.. Now I'm without my FreeBSD system.
What could be the problem that it cannot mount /usr ?
I've made a fresh minimal install on my system and after that tried to install the fusefs-ntfs port again and it crashed my system one more time
It printed some output about the crash, but I was not able to write down all of it, but this was the first line of the crash:
Fatal trap 12: page fault while in kernel mode
This was the error or something like that followed by some other lines of output.
Does anyone have experienced something like that?
I've found this thread:
It is supposed to fix the problem after I remove these options from my kernel, but in fact I don't even have these options in my custom kernel...
FreeBSD Handbook - The Power to Serve!
Last edited by daemonFromHeaven; 10th September 2008 at 02:36 PM.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Mounting ntfs drive as rw using fusefs-ntfs||caesius||FreeBSD General||3||12th October 2008 12:08 PM|
|fusefs-kmod: requires the userland sources to be installed?||zelut||FreeBSD Ports and Packages||2||7th October 2008 11:39 PM|
|Cannot mount (NTFS)||IIMarckus||OpenBSD General||4||11th August 2008 09:44 PM|
|mount fusefs (sshfs) from fstab||elon||FreeBSD General||4||29th July 2008 07:41 PM|
|Problem updating fusefs-kmod||Malakim||FreeBSD Ports and Packages||6||25th July 2008 01:40 PM|