Adding a separate /home
I just built a new computer and it has two hard drives in it. I was originally going to put them into RAID1, but since the onboard controller turned out to basically be a software controller and not a true hardware one, it was too much of a headache to configure right now. What I now want to do is use the second disk (partially) as a /home that I can maintain during upgrades, etc. I have one setup like this for Slackware already, but I'm trying to get this accomplished in NetBSD. Here is the setup:
sda1 - Slackware
sda2 - Linux swap
sda3 - NetBSD
sda4 - (probably) NetBSD-testing
sdb1 - Slackware /home
sdb2 - NetBSD /home
It is the sdb2 that I need to get configured. I need to format it (I assume that will be done using fdisk), and then configure NetBSD on sda3 to mount it as /home (edit fstab?).
I have an idea of how to accomplish this, but not entirely (especially the fine details - still learning BSD).
What I figure is format it with fdisk (not certain of the correct format and sequence of the switches) and then edit fstab to have it mount.
Is that the correct fstab entry?
And the WORD was made flesh, and dwelt among us. (John 1:14)
Most likely, the second disk will be /dev/wd1 which can be confirmed in the output of dmesg(8). By the time you see dmesg(8) output, you will have already resolved the problem of ensuring that the BIOS is booting the correct drive. If you end up fighting this battle, there will either be a BIOS setting that controls which drive is used for booting, or else you will have to determine which IDE channel is for the boot device by swapping cables.
Once the second drive is partitioned in the MBR sense, you will need to create any NetBSD slice needed (outside of slice d which is defined by default...) through disklabel(8). Once all NetBSD slices needed have been defined, each NetBSD filesystem will need to be initialize via newfs(8) (excluding slice d or b if defined...). Note that slices will not be able to be mounted until newfs(8) has been used to initialize them. You will need to boot NetBSD with the second drive attached & initialize each slice before mounting either manually or entering into fstab(5).
Note that the installation program performs the very same steps:
...which diagrammatically describes how NetBSD slices relate to the overall disk. Slice b is always used for swap if any swap space is allocated, & slice d always represents the entire disk. Any other slice can be used for any other use, however by convention, a is considered to contain a bootable kernel.
Yes, it is unfortunate that the term "partition" in the Intel world contradicts what is meant in the *BSD world, but that is the way it is. The *BSD concept transcends platforms, so the terminology comes from a different focus.
Last edited by ocicat; 28th August 2008 at 10:14 PM.
|Thread||Thread Starter||Forum||Replies||Last Post|
|What are rules about adding commands to mfsroot?||PeterSteele||FreeBSD Installation and Upgrading||12||18th November 2008 04:21 PM|
|Adding drives annoys OpenBSD.||diw||OpenBSD General||4||4th September 2008 03:14 AM|
|Adding Additional Video Card||JMJ_coder||General software and network||0||19th July 2008 08:16 PM|
|Having trouble adding 7.0 to GRUB 0.97||Arenlor||FreeBSD General||4||26th June 2008 02:02 AM|
|/etc on a separate partition||DarkEnergy||FreeBSD Installation and Upgrading||13||20th May 2008 05:24 AM|